|
An another product called: * Cyper WP has the exact same label, but is less expensive than Demon WP.
DEMON WP-AT A GLANCE CHART
|
| Active Ingredient |
|
Cypermethrin 40.0%
|
| Target Pest: |
|
ants, boxelder bugs,carpenter ants, centipedes,cockroaches, crickets, firebrats, millipedes,silverfish,scorpions,spiders,wasps and certain other insect pests.
|
| Pet/Children Safe: |
|
Yes, when used as directed.Keep off of wet surface until they dry. |
| Usage Sites: |
|
For you in an around buildings and structures for listed pests.Residential, institutional, public, commerical, agricultural and industrial buildings |
| Application: |
|
A general surface, crack and crevice and/or spot treatment for residual control.
Use between 1-2 packets(Envelopes)/ or 1-2 scoops(Tubs) per gallon of water for a concentration of 0.1%-0.2% of active ingredient.
|
| Yield: |
|
One envelope yields 2-4 gallons.One tub yields 24-48 gallons.
|
| Retreatment: |
|
Every 2-3 months, more often during heavy rainfall |
| Cautions |
|
Demon WP leaves a white powdery film that is especially noticeable on dark surfaces.Use Cyonara 9.7 too avoid visible residues. |
| Cannot be shipped to : |
|
NY. or CT. |
SPECIFIC USE DIRECTIONS OF DEMON WP
Each l envelope of Demon WP Insecticide contains four water-soluble packets of Demon wettable powder (WP). The envelope must be opened for use. Because water-soluble packets (inside)readily dissolve in the presence of moisture, do not allow them to get wet before adding to the applicator tank.
Wear dry gloves when handling the water-soluble packets. Handle with care because excessive handling may cause rupture of the water-soluble packet. Unused water-soluble packets should be stored in the original foil envelope, folded over to minimize exposure to moisture.
Demon WP Insecticide in Water-Soluble Packets are intended for dilution with water for applications. For best results, dilution should be achieved if the following steps are taken:
1. Fill applicator tank 1/2 with water.
2. Add desired Demon WP Insecticide in Water-Soluble Packet(s) Use 1-2 packets per gallon
3. Allow 1-2 minutes for dissolution of water-soluble packet(s).
4. Agitate, stir or shake applicator tank.
5. Finish filling applicator tank and agitate again before use to ensure satisfactory suspension.
Note:
• Upon standing without agitation for more than 1 hr., the applicator tank should be agitated, stirred or shaken again to achieve satisfactory suspension.
• Make up only amount of application volume as required.
• This product should not be applied with oil.
Tank Mixing
Demon WP Insecticide in Water-Soluble Packets may be tank mixed with other currently registered pesticides unless expressly prohibited by the product label. A small volume mixing test with the other products is recommended to ensure compatibility. Observe all restrictions and precautions which appear on the labels of these products.
INDOOR SURFACES USE
Cockroaches, Spiders, Crickets, Scorpions, Silverfish, Ticks, and Firebrats Treatment with Demon WP:
Apply Demon WP as a coarse, low pressure treatment to areas where these pests hide, such as baseboards, corners, storage areas, closets, around water pipes, doors and windows, attics and eaves, cabinets, furniture, sinks, furnaces, stoves, behind and under refrigerators, the underside of shelves, drawers, and similar areas. Pay particular attention to cracks and crevices. Also see Outdoor Surfaces Use.
Ants Treatment with Demon WP:
Apply Demon WP to any trails, around doors and windows, and similar areas where ants (including carpenter ants) may be found. Where ants are trailing inside, apply as a residual surface treatment to active areas such as baseboards, corners, around pipes, in and behind cabinets, behind and under refrigerators, sinks, furnaces and stoves, cracks and crevices. When combining baits and residual surface insecticides, apply surface insecticides in cracks and crevices, along baseboards, and infested surfaces and outside barrier treatments, do not allow residual insecticide to touch the bait.
Apply perimeter barrier treatments and treat nest to prevent infestation as described in Outdoor Surfaces Use.
A better choice of insecticide for ants may be the use of Non Repellent Insecticides such as Dominion 2L or Termidor SC f or ant control outside. The ants cannot detect it and go around it as they can with repellent insecticides such as Demon WP or Cyper WP.
Assassin Bugs, Boxelder Bugs, Sowbugs, Pillbugs, Millipedes, Elm Leaf Beetle, and Centipedes Treatment with Demon WP:
Apply Demon WP around doors and windows and similar areas where these, or similar perimeter pests, may be found or where they may enter premises. Apply Demon WP to baseboards, storage areas, and other locations. Apply perimeter barrier treatments to prevent infestation as described in Outdoor Surfaces Use.
OUTDOOR SURFACES USE with Demon WP
Apply Demon WP with either hand-held or power application equipment as a residual spray to surfaces of buildings, porches, screens, window frames, eaves, patios, lawns, refuse dumps, garages and other similar areas where these pests are found. Also, may be used as a spot treatment in applications to lawns in landscaped areas in and around residential, commercial, institutional and industrial buildings, and similar areas where these insect pests are active.
Carpenter Ants Treatment with Demon WP:
Apply Demon WP as a coarse wet spray treatment, but avoid runoff around doors, door frames, windows and similar areas where these ants enter premises or hide.
Fire Ants (Mounds) Treatment with Demon WP:
For individual fire ant mounds, apply Demon WP as a drench. Gently sprinkle a total of one gallon over the surface of mounds up to 12 inches in diameter. Use 2 gallons for larger mounds. Thoroughly wet mound and surrounding area. Treat new mounds as they appear. Pressurized sprays may disturb the ants and cause migration. If possible, applications should be made on warm days after recent rainfall All colonies in the vicinity should be treated, including those that have not yet constructed a mound.
Bees, Flies, Mosquitoes, and Wasps Treatment with Demon WP:
Apply directly to walls, window screens, and other exterior resting areas as a residual surface treatment. Use caution when treating nests of stinging insects as Demon WP does not provide instant knockdown.Protective equipment for the applicator may be required. For best results, treat bee, wasp and hornet nests late in the day when most insects will be present. Allow 2-3 days for colony to die.
For mosquito control, apply as a general structural perimeter spray to landscape plantings, turf, and building foundations to control mosquitoes. Yards or other frequented areas enclosed by landscaping can benefit from the creation of a mosquito barrier to reduce invading mosquitoes by the treatment of perimeter vegetation. For best results, apply Demon WP at recommended rates in 2-5 gallons of water per 1,000 sq. ft. Higher volumes applied result in better coverage and, as a rule, will improve control. Application to vegetation away from structures may require additional applicator certification, e.g. in turf or ornamental categories. Consult your state regulatory agency for requirements. Not for use in wide area mosquito abatement programs.
Cluster Flies Treatment with Demon WP:
Make exterior treatments in late summer or early fall before flies are observed alighting on surfaces. Apply Demon WP thoroughly on siding, under eaves, and around windows and doors, paying particular attention to south-facing surfaces. Apply Demon WP just enough dilution to adequately cover the area without excessive dripping or runoff. Heavy precipitation prior to frost may require re-treatments to maintain protection.
Scorpions Treatment with Demon WP:
Treat and remove accumulations of lumber, firewood and other materials that serve as harborage sites. Apply as a coarse spray treatment to the point of drip.
Sod Webworms Treatment with Demon WP:
Apply Demon WP as a spot treatment when pests first appear (do not apply as a broadcast spray). Delay watering or mowing the treated area for 12-24 hours after treatment. Use 1-5 gallons of solution per 800-1,600 sq. ft. when making application. Retreat when needed but not more than every two weeks.
OUTDOOR PERIMETER BARRIER TREATMENT AROUND STRUCTURES
Applying a continual band of insecticide around a building foundation and around windows, doors, service line entrances, eaves, vents, and other areas can greatly reduce the potential for entry by crawling pests. To facilitate application, remove debris and leaf litter from next to the foundation, trim vegetation and branches that touch the foundation, and move or rake back rocks, deep mulch, or other potential pest harborage next to the foundation. To help prevent infestation of buildings, apply as a band to soil and vegetation 6-10 ft. wide around and adjacent to the building. Also, treat the building foundation to a height of 2-3 ft. where pests are active and may find entrance. Apply as a coarse spray treatment to thoroughly and uniformly wet the band area, using 1-5 gallons of treatment solution applied to 800-1,600 sq. ft.
Amount of concentrate is dependent upon pest species (see pest table and comments), infestation levels, and service interval desired.
|