Carpenter Bee Kit with Cyper WSP
The Carpenter Bee Kit with Cyper WSP contains Cyper WSP, D-Fense Dust and JT Eaton's Bellow duster.
Cyper WSP, a cypermethrin product formulated in a wettable powder has long been a standby in killing carpenter bees.Cyper WSP may also be used to spray other crawling and flying insects around your home. It has been a top seller for years. Cyper WSP will leave a milky type of residual that can be seen against dark surfaces. If you have lighter surfaces, it will not show.
Carpenter Bee Kit with Cyper WSP to kill carpenter bees contains:
- (3) Envelopes of Cyper WSP (12 water soluble packets -makes 6-12 gallons) (Valued at $22.95)
- 1 -JT Eaton's Bellow Duster (Valued at $15.99)
- 1-1 lb. of D-Fense Dust (Valued at &15.90)
- All valued at $54.84 for $39.95. Save over $14.00.
- Click here Carpenter Bee Information
How To Kill Carpenter Bees
If you do have an active carpenter bee & infestation, following these steps below would ensure success.
- Mix the Cyper WPS at 2 packets per gallon of water and spray the areas where carpenter bees are boring or have bored in the past. The goal here is to use a spray pattern that clings to the surface. This will leave a repellent residue on the surface which will discourage the bees from drilling additional holes. Their holes are usually located on the underside of any wood surface including siding, soffits, overhangs, decks, fence posts, fascia boards and window frames. We recommend spraying twice during the spring at intervals of 3-4 weeks. For severe infestations of carpenter bees on cedar and log structures you may need to treat more frequently
- Next fill the JT Eaton Bellow Duster about halfway with D-Fense Dust and puff it into all accessible carpenter bee holes. Shake the duster vigorously and puff it 2 or 3 times into each hole. Holes that are too high to reach with the duster may have to be sprayed using the sprayer and the Cyper WPS. Setting the sprayer nozzle to a stream will allow it shoot much farther. Sometimes carpenter bee holes will be behind shutters, trim boards, gutters, etc. Dust or spray the area around their access point so that they have to crawl through some insecticide to get in or out.
- We know it tempting to seal the holes now, but we recommend waiting until the fall. This gives any surviving eggs or adults time to hatch and leave. When sealing the holes, be sure to use a sealant that can be painted over. As with all pesticides: Always read and follow the label instructions. Should you have any questions feel free to call us at 800-476-3368 or email us at E mail - Here