B&G Fogger Flex A Lite 2600
B&G Flex A Lite 2600 Fogger
The heavy-duty foggers from B&G are used for flying insect control around the world. They are ideal for commercial and residential accounts because of their compact size, stability, and the 1.5 gals. capacity.
The handle and tank are one-piece construction and the unit is rotation-molded for maximum strength. The droplet size available with the 2400 and 2600 models extends from a power-mist (56-micron droplets) to ULV (20-35 micron droplets). The output and droplet size of these models can be easily selected with the adjustment knob on the nozzle.
- The 2600 (Flex-A-Lite) has an 18 inch or 48-inch flexible hose for directing the spray to specific sites.
- The 2600 (Flex-A-Lite) comes in 110v or 220v
- Each fogger is individually built and tested for performance.
The B&G Flex A Lite 2600 Fogger provides the widest range of options for cold fog applications. The nozzle, attached to the flex hose, allows the user to easily direct the fog in, under, and at objects. The convenient flow adjustment knob located at the nozzle enables the operator to change the liquid flow rate being dispensed.
Flying insects and crawling insects such as ants, cockroaches, fleas, food product pests (grain beetles, weevils and moths), fabric pests such as clothes moths, drywood termites, silverfish, etc.
Where to Use It:
Attics, crawl spaces and other areas where you need large volumetric coverage and where there is limited accessibility.
Rate of Application and Directions:
The operator can adjust the liquid flow to dispense materials at average droplet sizes under 20 microns(water-based chemicals at room temperature). Droplets of this size remain suspended in the air for extended periods of time and are used primarily for insecticide applications to control flying insects.
Droplet size will increase as the flow rate is increased and will average approximately 80 microns when the liquid flow is adjusted for maximum output. Larger droplets are dispersed by airflow and can settle on surfaces. This characteristic makes them useful for applying disinfectant, deodorizer, and chemicals used for coating insides of heat ducts or other surfaces.
Conduct a pretreatment walk-through and inspection to ensure that nothing is left to chance. Shut off pilot lights and gas flames. Turn off exhaust fans and air vents to keep material from drifting out of desired areas. Set up andy necessary air circulating instruments, such as fans, in the areas to be treated.
Caution: Always wear the appropriate protective clothing as specified in the chemical's product label and follow the label instructions.
Fill the unit with the designated amount of chemical
- Place the machine in the appropriate location for the fogging application
- Set the desired flow rate by turning the liquid flow adjustment knob located at the nozzle t the desired position. The output chart on the unit should be used as a guide.
- Turn the unit on and operate for the time calculated.
- Prior to turning the unit off, turn the liquid flow adjustment to the "off" position.
The fogger delivers a wet fog. Care must be taken to prevent wetting action on the surfaces near the fogging machine. Time the application carefully to ensure that the proper dosage of material is used.
|Pro Tips||All of the B&G foggers are made in the USA. I would take them over the Fogmaster any day. We also carry that fogger in a 48 inch hose. If you want a fogger that will put out a wider range of volume you might want to check out the 2790 Hurricane fogger. It is about the same price and is made up in Indiana.|
|Active Ingredient (s)||N/A|
|For Use :||N/A|