Annual Weeds such as Bluegrass, annual, buttercup, chickweed, museear, crabgrass, foxtail, horseweed, lambsquarters, common, rye, sanbur, shepherdspurse, stinkgrass and more listed.
Perennial Weeds such as Alligator weed, Alfalfa, Bahiagrass, Bermudagrass, Bindweed, field, Cararygrass, reed, cover, white, Dallisgrass, Dandelion, Fescue, Horsenettle, Knapweed, Milkweed, and more listed on the label.
Woody Brush and Trees such as Alder, Ash, Birch, Broom, Dewberry, Elm, Hawthorn, Oak, Poison Ivy, Poison Oak, and more listed on the label.
May use low volume garden sprayers, boom equipment or hand held high volume equipment such as knapsack sprayers. Use coarse sprays only. Applications should be made on a spray-to-wet basis. Spray coverage should be uniform and complete. Do not spray to point of runoff.
For low volume hand held sprayers use 5-8 percent solution for spot treatment of brush and trees It is most effective in areas where there is a low density of undesirable trees or brush. If a straight stream nozzle is used, start the application at the top of the targeted vegetation and spray from top to bottom in a lateral zigzag motion. Ensure that at least 50 percent of the leaves are contacted by the spray solution. For flat fan and cone nozzles and with hand-directed mist blowers, mist the application over the foliage of the targeted vegetation. Small, open-branched trees need only be treated from one side. If the foliage is thick or there are multiple root sprouts, applications must be made from several sides to ensure adequate spray coverage..
Annual Weeds:Broadcast Application Use 1 1/2 pints of this product per acre plus 2 or more quarts of a nonionic surfactant per 100 gallons of spray solution if weeds are less than 6 inches tall. If weeds are greater than 6 inches tall, use 2 1/2 pints of this product per acre plus 2 or more quarts of an approved nonionic surfactant per 100 gallons of spray solution. Hand-Held, High-Volume Application – Use a 3/4 percent solution of this product in water plus 2 or more quarts of a nonionic surfactant per 100 gallons of spray solution and apply to foliage of vegetation to be controlled.
Apply this product as follows to control or destroy most vigorously growing perennial weeds. Unless otherwise directed, allow at least 7 days after application before disturbing vegetation.
Add 2 or more quarts of a nonionic surfactant per 100 gallons of spray solution to the rates of this product given in this list. See the “General Information,” “Directions for Use” and “Mixing and Application” sections in this label for specific uses and application instructions.
NOTE: If weeds have been mowed or tilled, do not treat until regrowth has reached the recommended stages. Fall treatments must be applied before a killing frost. Repeat treatments may be necessary to control weeds regenerating from underground parts or seed.
This product may be applied to emerged weeds in all bodies of fresh and brackish water which may be flowing, non-flowing or transient. This includes lakes, rivers, streams, ponds, estuaries, rice levees, seeps, irrigation and drainage ditches, canals, reservoirs, wastewater treatment facilities, wildlife habitat restoration and management areas, and similar sites.
If aquatic sites are present in the non-crop area and are part of the intended treatment, read and observe the following directions: This product does not control plants which are completely submerged or have a majority of their foliage under water. There is no restriction on the use of treated water for irrigation, recreation or domestic purposes.
Consult local state fish and game agency and water control authorities before applying this product to public water. Permits may be required to treat such water.